Grout Sealer

A$27.00
In stock
SKU
CTG02-200
Aqua Mix Grout Sealer is a water-based sealer that resists water oil and acid-based contaminants. Simplifies maintenance and does not change the appearance of the grout. Allows moisture vapor transmission.
Aqua Mix Grout Sealer is a water-based sealer that resists water oil and acid-based contaminants. Simplifies maintenance and does not change the appearance of the grout. Allows moisture vapor transmission.

USES:
• Recommended for use on cementitious sanded and unsanded grout joints for ceramic tile installations
• Equally effective for interior and exterior applications

COVERAGE:
• Approximately 400 to 1 200 sq. ft. (35 m2 to 110 m2) per coat per gallon (3.875 L) depending on size and porosity of grout joint temperature and method of application

EXPECTED WEAR:
• Will vary depending on hardness and texture of surface type of area surface wear frequency and type of maintenance products used the expected wear is up to 5 years. Extreme weather conditions harsh cleaning methods and high-alkaline or solvent-based cleaners will affect wear.

METHOD OF APPLICATION:
• Read entire label before using
• TEST A SMALL AREA according to application instructions with a 24-hour cure time to determine desired results. Test for stain repellency using likely contaminants.
• For new installations sealer can be applied 48 hours after grouting
• Grout joints must be clean dry and free of existing sealers and coatings
• Apply 1 to 2 coats with a soft-bristle paint brush or sponge paint applicator
• Using cotton or paper towels polish dry any sealer remaining on the tile and grout within 3 to 5 minutes after application of each coat
• Clean applicator tools with water after each use.

CURE TIME:
• If 2 coats are applied allow a minimum of 30 minutes drying time between coats
• Ready for surface traffic 2 hours after final coat
• Sealed area should be kept dry for 12 hours
• Achieves a full cure in 24 hours
• Conduct a test to determine if surface is completely sealed after 2 hours by applying water droplets to the surface. If water is absorbed apply an additional coat. Wait 2 hours and repeat the test.

MAINTENANCE:
• Aqua Mix Concentrated Tile Cleaner and/or Aqua Mix Tile Plus More Cleaner are recommended for routine cleaning

LIMITATIONS:
• Do not allow sealer to dry on tile surface because a residue will be visible. If this occurs use Aqua Mix Poultice or Aqua Mix Stone Poultice mixed with water into a wet slurry and scrub with a nylon pad.
• Do not allow sealer to come in contact with any nonrecommended surface

HANDLING AND STORAGE:• Close container after each use
• Store in original container only
• Store and use in temperatures between 50? F and 80? F (10? C and 27? C)
• Protect unused stored product from freezing

CAUTION:
• KEEP OUT OF REACH OF CHILDREN
• Eye and skin irritant
• May be harmful if swallowed
• Contains siliconates
• Do not take internally
• Rubber gloves and eye protection should be worn during application
• IF INGESTED: Do not induce vomiting. Drink 1 to 2 glasses of water. Seek immediate medical attention.
• EYE CONTACT: Flush thoroughly with water. Seek immediate medical attention.
• SKIN CONTACT: Flush with water
form-get-image